Sprinter 3500 V6-3.0L DSL Turbo (2008)
Auxiliary Water Pump: Service and Repair
Removal
REMOVAL
WARNING: Review safety precautions and warnings in this group before performing this procedure See: Service Precautions/Warning and
See: Service Precautions/Caution. Failure to follow the warnings and cautions may result in serious or fatal injury.
1. Disconnect and isolate the negative battery cable.
2. Partially drain the engine cooling system See: Engine, Cooling and Exhaust/Cooling System/Service and Repair.
3. Remove the air cleaner housing from the engine compartment See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance
Checks/Air Cleaner Housing/Service and Repair.
4. Disconnect the wire harness connector (1) from the electric coolant pump (2).
5. Loosen the hose clamps (4) from the electric coolant pump.
6. Using a twisting motion gently remove both heater hoses (3 and 6) from the electric coolant pump.
7. Remove the electric coolant pump from the bracket (5).