Sprinter 3500 V6-3.0L DSL Turbo (2008)
-
The parking lamps
-
The tail lamps
-
The license plate lamp
-
The front foglamps
You can reactivate this function by opening a door within 10 minutes. The lights are switched off after 60 seconds if you do not open a door or if you
close an opened door after the engine has been switched off.
7. Press the PLUS or MINUS to select the Lighting submenu.
8. Press the UP ARROW or DOWN ARROW button repeatedly until you see the "Headlamps" message in the display. The current setting is
highlighted.
9. Press the PLUS or MINUS button to select whether and for how long the lights should remain on.
VEHICLE SUBMENU
You can reach the Vehicle submenu via the Settings menu. The following are the settings you can make in the Vehicle submenu:
-
Set station selection
-
Set the windshield wiper sensitivity
Setting the windshield wiper sensitivity
You can use the Wiper sensor function to set the sensitivity of the rain sensor.
1. Press the PAGE FORWARD or PAGE BACKWARDS button repeatedly until you see the "Vehicle" message in the display.
2. Press the UP ARROW or DOWN ARROW button repeatedly until you see the "Wipe sensor" message in the display. The current setting is
highlighted.
3. Press the PLUS or MINUS button to select the level of sensitivity of the rain sensor.
-
Level 1: High sensitivity Wiping beings in light rain
-
Level 2: Moderate sensitivity
-
Level 3: Low sensitivity. Wiping only begins in heavy rain.
CONVENIENCE SUBMENU
You can reach the Convenience submenu via the Settings menu.
Key-dependent settings
You can use the Key function to determine whether the settings in the following Submenus are stored as key-dependent settings:
-
Instrument cluster
-
Lighting
-
Vehicle
NOTE: For safety reasons, it is not possible to set the Key function while the vehicle is in motion. You will see the following message in the
display: Setting only possible at standstill.
1. Press the PAGE FORWARD or PAGE BACKWARDS button repeatedly until you see the "Convenience" message in the display.
2. Press the UP ARROW or DOWN ARROW button repeatedly until you see the "Key" message in the display. The current setting is highlighted.
3. Press the PLUS or MINUS button to switch key dependence On or Off.
TRIP COMPUTER MENU