Sprinter 3500 V6-3.0L DSL Turbo (2008)
7. Lift the webbing (2) for each seat belt to access and remove the plastic push pin fastener (3) that secures the rear seat belt turning loop trim cover
(1) to the turning loop bracket at the top of the seat back (4).
8. Remove the trim covers from the turning loop brackets and the seat belts.
9. Remove the trim cover and padding from the rear seat back. See: Body and Frame/Seats/Seat Back/Service and Repair/Seat Back Cushion / Cover
- Removal.
10. Remove the cover (1) from the back of the rear seat back frame (2).
11. Remove and discard the push nut (4) from the pivot pin (1) at the back of the rear seat back frame turning loop bracket that secures the two turning
loops (2) and the two bushings (3).
12. Remove the pin, the two turning loops and the two bushings from the turning loop bracket.
13. Route the seat belt latch plate (1), lower anchor (6) and webbing (3) through the two turning loops (2) and the turning loop bracket at the top of the
seat back frame.
14. Remove the screw (4) that secures the rear seat belt retractor (5) to the bracket on the back of the rear seat cushion frame.
