Sprinter 3500 V6-3.0L DSL Turbo (2008)
Front Right - Passenger Bench Seat
FRONT RIGHT - PASSENGER BENCH SEAT
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler
Mopar(R) Parts Catalog.
1. Position the spacer and the front right seat belt buckle (1) to the center of the front passenger bench seat back frame. Be certain to route the wire
harness for the center seat belt retractor (3) over the top of the spacer.
2. Install and tighten the screw (2) that secures the buckle lower anchor to the center of the seat back frame. Tighten the screw to 37 Nm (27 ft. lbs.).
3. Restore the passenger side seat cushion to its normal seating position.
Rear Inboard
REAR INBOARD
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler
Mopar(R) Parts Catalog.
NOTE: The following procedure may be used to service an inboard seat belt buckle on either a two or a three-position rear bench seat.
1. Position the inboard rear bench seat belt buckle (4) and the lower anchor spacer to the rear seat cushion frame (1).
2. Install and tighten the screw (2 or 3) that secures the buckle to the seat frame. Tighten the screw to 37 Nm (27 ft. lbs.).
3. Reinstall the plastic trim shield onto the back of the rear seat. See: Body and Frame/Seats/Seat Back/Service and Repair/Rear Seat Back
Shield/Installation.
4. Reinstall the seat into the vehicle.
Rear Outboard
REAR OUTBOARD
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
