Sprinter 3500 V6-3.0L DSL Turbo (2008)
Seat Belt Height Adjuster: Service and Repair
Removal
REMOVAL
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler
Mopar(R) Parts Catalog.
1. Disconnect and isolate the battery negative cable. Wait two minutes for the system capacitor to discharge before further service.
2. On the driver side and on vehicles equipped with a passenger side bucket seat, adjust the front seat to its most forward position for easiest access
to the B-pillar trim.
3. Remove the trim from the inside of the B-pillar (3). See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar
Trim/B-Pillar Trim.
4. Remove the screw that secures the front outboard seat belt turning loop to the height adjuster (2) on the upper inner B-pillar.
5. Remove the turning loop from the height adjuster.
6. Remove the two screws (1) that secure the height adjuster to the B-pillar.
7. Remove the adjuster from the vehicle.
