Sprinter 3500 V6-3.0L DSL Turbo (2008)
11. Install and tighten the screws (4) that secure the lower anchors to the rear seat cushion frame. Tighten the screws to 37 Nm (27 ft. lbs.).
12. For the left outboard seating position only, reinstall the plastic trim cap (5) onto the screw that secures the lower anchor to the left outboard end of
the seat cushion frame.
13. Reinstall the seat belt buckle onto the right outboard end of the rear seat.See: Seat Belt Buckle/Service and Repair/Seat Belt Buckle - Installation.
14. Reinstall the molded plastic shield onto the back of the rear seat. See: Body and Frame/Seats/Seat Back/Service and Repair/Rear Seat Back
Shield/Installation.
15. Reinstall the rear passenger bench seat into the vehicle.
