Sprinter 3500 V6-3.0L DSL Turbo (2008)
1. Position the side impact sensor (2) to the bracket (3) welded to the base of the inner right or left B-pillar (4).
2. Install and tighten the screw (1) that secures the side impact sensor to the bracket. Tighten the screw to 8 Nm (71 in. lbs.).
3. Reconnect the vehicle wire harness connector (5) to the sensor connector receptacle.
4. Reinstall the trim paneling to the interior of the right or left front door step well. See: Body and Frame/Interior Moulding / Trim/Scuff
Plate/Service and Repair/Door Sill Scuff Plate - Installation.
5. Do not reconnect the battery negative cable at this time. The supplemental restraint system verification test procedure should be performed
following service of any supplemental restraint system component. See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests.
