Sprinter 3500 V6-3.0L DSL Turbo (2008)
Wheel Speed Sensor: Service and Repair
Tone Wheel
Removal
REMOVAL - DUAL REAR WHEEL (DRW)
NOTE: The tone wheel for single rear wheel (SRW) is integrated into the wheel hub/bearing assembly and not serviced separately.
1. Remove the hub/bearing assembly (DRW) (3) See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Bearing/Service and
Repair/Bearing/Seal-Axle/Removal See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Bearing/Service and
Repair/Bearing/Seal-Axle Hub/Removal.
2. Insert a hooked prybar (1) between the hub/bearing and the inside of the tone wheel and pry upwards slightly and work your way around the tone
wheel until the wheel is loose.
3. Remove the tone wheel (2).
Installation
INSTALLATION - DUAL REAR WHEEL (DRW)
1. Install the tone wheel to the hub/bearing with a thin bead of silicone around the tone wheel.
2. Tap the tone wheel down with a soft hammer until seated.
3. Install the hub/bearing (DRW) See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Bearing/Service and
Repair/Bearing/Seal-Axle/Installation See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Bearing/Service and
Repair/Bearing/Seal-Axle Hub/Installation.
