Sprinter 3500 V6-3.0L DSL Turbo (2008)
Tire Pressure Sensor: Service and Repair
Installation
INSTALLATION
NOTE: Before reinstalling an existing tire pressure sensor (6), replace valve cap (2), valve core and sensor seal (4) to ensure proper sealing.
1. Wipe area clean around sensor/valve stem mounting hole in wheel. Make sure surface of wheel is not damaged.
2. Insert sensor (1) through wheel (2) as shown keeping pressure against rear of metal valve stem (See Arrow). Potted side of sensor is to be
positioned toward wheel. Damage to the sensor may occur if the sensor is installed incorrectly.
3. Install sensor nut (3) and hand tighten.
NOTE: Before tightening sensor nut, push downward on sensor housing (2) in an attempt to make it flush with interior contour of wheel
(1).
4. While holding sensor in position, tighten sensor nut to 6 Nm (53 in. lbs.).
CAUTION: Over-tightening the sensor may result in sensor separation from the valve stem. Under this condition, the sensor may still
function, however, the condition should be corrected immediately.
5. Mount tire on wheel following tire changer manufacturer's instructions, paying special attention to the following to avoid damaging tire pressure
sensor:
a.
