Sprinter 3500 V6-3.0L DSL Turbo (2008)
Wiper Motor: Service and Repair
Wiper Motor - Installation
INSTALLATION
1. Install a new rear wiper motor output shaft sealing grommet (4) in the rear door, if necessary.
2. Position the rear wiper motor (5) into the rear door.
3. Install and tighten the screw (6) that secures the motor to the rear door. Tighten the screw to 7 Nm (5 ft. lbs.).
4. Reconnect the washer hose (3) to the fitting on the motor.
5. Reconnect the vehicle wire harness connector (2) to the motor.
6. Reinstall the lower trim panel (7) onto the inside of the rear door. See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Rear Door
Panel/Service and Repair/Rear Door Trim Panel - Installation.
7. Reinstall the rear wiper arm and blade (1) onto the rear wiper motor output shaft. See: Wiper Arm/Service and Repair/Wiper Arms - Installation.
8. Reconnect the battery negative cable.
