Sprinter 3500 V6-3.0L DSL Turbo VIN 45 (2007)
NOTE: The alignment marks should be touching and the exhaust camshaft drive gear alignment pin should be located at approximately
12 o'clock, when viewed from the front camshaft seal.
6. Assure the proper positioning of the camshaft gear alignment marks and install the camshaft driven gear onto the exhaust camshaft alignment
dowel.
7. Install two of the drive gear bolts. Tighten the bolts to 18 Nm (13 ft. lbs.).
8. Assure proper positioning of the timing chain to drive gear paint or scribe marks and remove the tie strap.
9. Rotate the engine by the vibration damper bolt enough to install the third camshaft drive gear bolt. Tighten the bolt to 18 Nm (13 ft. lbs.).
10. Rotate the engine back to TDC and check camshaft gear alignment.
NOTE: If the camshaft endplay is not within specification, replace the cylinder head and cylinder head cover.
11. Install the timing chain tensioner.
12. Install the left front camshaft oil seal (2).
