Sprinter 3500 V6-3.0L DSL Turbo VIN 45 (2007)
1. Disconnect and isolate the negative battery cable.
2. Remove the glove box from the instrument panel.
3. Remove the blower motor from the HVAC housing.
4. Remove the two screws (2) that secure the recirculation door actuator (3) to the passenger side of the HVAC housing (4).
5. Remove the recirculation door actuator from the HVAC housing and disconnect the HVAC wire harness connector (1) and remove the actuator
from the vehicle.
Installation
INSTALLATION
1. Position the recirculation door actuator (3) to the passenger side of the HVAC housing (4) and connect the wire harness connector (1) to the
actuator.
2. Install the recirculation door actuator onto the HVAC housing. If necessary, rotate the actuator slightly to align the spline on the actuator with the
recirculation-air door.
3. Install the two screws (2) that secure the recirculation door actuator to the HVAC housing. Tighten the screws to 2 Nm (17 in. lbs.).
4. Install the blower motor.
5. Install the glove box.
6. Reconnect the negative battery cable.
7. Initiate the Actuator Calibration function using a scan tool.
