Sprinter 3500 V6-3.0L DSL Turbo VIN 45 (2007)
lbs.).
7. Install the center and front headliner panels.
8. Install the rear roof ducts.
9. Reconnect the negative battery cable.
10. Evacuate the rear refrigerant system.
11. Adjust the refrigerant oil level.
12. Charge the rear refrigerant system.
Removal
REMOVAL
WARNING: Review safety precautions and warnings before performing this procedure. Failure to follow the warnings and cautions may
result in serious or fatal injury.
1. Disconnect and isolate the negative battery cable.
2. Recover the refrigerant from the rear refrigerant system.
3. If servicing the front portion of an underbody refrigerant line, disconnect the underbody line being serviced from the rear A/C compressor located
in the engine compartment.
4. Remove the bolts (1) as necessary that secure the rear underbody suction line (2) or the rear underbody discharge line (4) from the front underbody
suction line (6) or the front underbody discharge line (5) located at the right front frame rail.
5. Disconnect the underbody refrigerant hoses as necessary and remove and discard the O-ring seal(s).
6. Remove the fasteners (3) as necessary that secure the rear underbody suction line and the rear underbody discharge line to the frame rail.
NOTE: Underbody suction line (driver side) shown. Underbody discharge line (passenger side) similar.
7. Raise and support vehicle.
8. Remove the bolt (3) that secures the rear underbody suction line (driver side) (2) or rear underbody discharge line (passenger side) to the interior
refrigerant line (1) located near the front door entry area.
9. Disconnect the rear underbody line being serviced and remove and discard the O-ring seal (5).
