Sprinter 3500 V6-3.0L DSL Turbo VIN 45 (2007)
Crankshaft Position Sensor: All Technical Service Bulletins
Recall 07V594000: Crankshaft Position Sensor Replacement
MAKE/MODELS: MODEL/BUILD YEARS:
Dodge/Sprinter 2500 2007
Dodge/Sprinter 3500 2007
Freightliner/Sprinter 2500 2007
Freightliner/Sprinter 3500 2007
MANUFACTURER: Sprinter Engineering & Compliance Support
NHTSA CAMPAIGN ID NUMBER: 07V594000
MFR'S REPORT DATE: December 19, 2007
COMPONENT: Engine and Engine Cooling: Engine: Diesel
POTENTIAL NUMBER OF UNITS AFFECTED: 6101
SUMMARY:
On certain utility vans, the crankshaft sensor in certain diesel engines could fail due to separation of bond wires from the lead frame in the sensor. This
results in an interruption in the electrical connection in the chip housing of the sensor.
CONSEQUENCE:
When this happens, the vehicles may lose power rather than enter a limp-home mode. In addition, the vehicle cannot be restarted after failure of the
electrical connection in the sensor, increasing the risk of a crash.
REMEDY:
Dealers will replace the crankshaft sensors. The recall is expected to begin during February 2008. Owners may contact Sprinter at 1-843-695-5000.
NOTES:
Customers may also contact The National Highway Traffic Safety Administration's Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153),
or go to http://www.safercar.gov.
