Sprinter 3500 V6-3.0L DSL Turbo VIN 45 (2007)
number)/ground number/splice number and component identification. Connector/ground/splice location charts in Connector, Ground and Splice
Locations reference the figure numbers of the illustrations.
The abbreviation T/O is used in the component location section to indicate a point in which the wiring harness branches out to a component. The
abbreviation N/S means Not Shown in the illustrations
Section Identification and Information
SECTION IDENTIFICATION AND INFORMATION
The wiring diagrams are grouped into individual sections. If a component is most likely found in a particular group, it will be shown complete (all wires,
connectors, and pins) within that group. For example, the Auto Shutdown Relay is most likely to be found in Powertrain/Drivetrain Systems , so it is
shown there complete. It can, however, be shown partially in another group if it contains some associated wiring.
Splice diagrams in Splice Information show the entire splice and provide references to other sections the splices serves. Splice Information only contains
splice diagrams that are not shown in their entirety somewhere else in the wiring diagrams.
Connector Pinouts shows each connector and the circuits involved with that connector. The connectors are identified using the name/number on the
diagram pages.
Removal
REMOVAL
1. Disconnect battery.
2. Release Connector Lock.
3. Disconnect the connector being repaired from its mating half/component.
4. Remove the dress cover (if applicable).
