dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Seat Belt|Removal|Page 5992 > < Seat Belt|Removal
Page 2
background image

10. Remove the cover (1) from the back of the rear seat back frame (2).

11. Remove and discard the push nut (4) from the pivot pin (1) at the back of the rear seat back frame turning loop bracket that secures the two turning

loops (2) and the two bushings (3).

12. Remove the pin, the two turning loops and the two bushings from the turning loop bracket.

13. Route the seat belt latch plate (1), lower anchor (6) and webbing (3) through the two turning loops (2) and the turning loop bracket at the top of the

seat back frame.

14. Remove the screw (4) that secures the rear seat belt retractor (5) to the bracket on the back of the rear seat cushion frame.
15. Remove the rear seat belt and retractor as a unit from the bracket on the rear seat cushion frame.

Front Center

FRONT CENTER

WARNING:  To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting
any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect
and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further
diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result
in accidental airbag deployment.

WARNING:  To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or

Seat Belt|Removal|Page 5992 > < Seat Belt|Removal