Sprinter 3500 V6-3.0L DSL Turbo VIN 45 (2007)
center buckle (1) and the left end of the bench seat riser (4).
2. Remove the screw (3) that secures the buckle lower anchor to the inboard side of the seat frame.
3. Remove the buckle and the spacer (2) from the inboard side of the seat frame.
Front Right - Passenger Bench Seat
FRONT RIGHT - PASSENGER BENCH SEAT
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler
Mopar(R) Parts Catalog.
1. Lift and pull the front of the passenger side front bench seat cushion forward, then tilt the rear edge of the cushion forward to access the storage
area and the lower anchor of the right seat belt buckle (1) below the seat cushion.
2. Remove the screw (2) that secures the buckle lower anchor to the center of the seat back frame.
3. Remove the buckle and the spacer from the center of the seat back frame.
Rear Inboard
REAR INBOARD
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler
Mopar(R) Parts Catalog.
NOTE: The following procedure may be used to service an inboard seat belt buckle on either a two or a three-position rear bench seat.
1. Remove the rear bench seat from the vehicle.
2. Remove the plastic trim shield from the back of the rear seat.
3. Remove the screw (2 or 3) that secures either inboard rear seat belt buckle (4) to the rear seat cushion frame (1).
4. Remove the buckle and the spacer from the seat frame.
