Sprinter 3500 V6-3.0L DSL Turbo VIN 45 (2007)
1. Position the side impact sensor (2) to the bracket (3) welded to the base of the inner right or left B-pillar (4).
2. Install and tighten the screw (1) that secures the side impact sensor to the bracket. Tighten the screw to 8 Nm (71 in. lbs.).
3. Reconnect the vehicle wire harness connector (5) to the sensor connector receptacle.
4. Reinstall the trim paneling to the interior of the right or left front door step well.
5. Do not reconnect the battery negative cable at this time. The supplemental restraint system verification test procedure should be performed
following service of any supplemental restraint system component.
