SRT-4 L4-2.4L Turbo VIN S (2004)
Antenna: Description and Operation
ANTENNA BODY AND CABLE
The antenna body and cable is secured below the fender panel by the antenna cap nut through a mounting hole in the right front fender. The primary
coaxial antenna cable is then routed beneath the fender sheet metal and through a entry hole in the right cowl side panel into the interior of the vehicle.
Inside the vehicle, the primary coaxial cable is connected to a secondary instrument panel antenna coaxial cable with an in-line connector that is located
behind the right kick panel. The secondary coaxial cable is then routed behind the instrument panel to the back of the radio.
The antenna body and cable connects the antenna mast to the radio. The radio antenna is an electromagnetic circuit component used to capture radio
frequency signals that are broadcast by local commercial radio stations in both the Amplitude Modulating (AM) and Frequency Modulating (FM)
frequency ranges. These electromagnetic radio frequency signals induce small electrical modulations into the antenna as they move past the mast. The
antenna body transfers the weak electromagnetic radio waves induced into the rigid antenna mast into the center conductor of the flexible primary
antenna coaxial cable. The braided outer shield of the antenna coaxial cable is grounded through both the antenna body and the radio chassis, effectively
shielding the radio waves as they are conducted to the radio. The radio then tunes and amplifies the weak radio signals into stronger electrical signals in
order to operate the audio system speakers.
