SRT-4 L4-2.4L Turbo VIN S (2004)
Front Door Window Glass Weatherstrip: Service and Repair
Front Vertical Guide Bar
FRONT VERTICAL GUIDE BAR
REMOVAL
1. Remove door trim panel and water dam.
2. Remove door speaker, if equipped.
3. Remove front lift guide.
4. Remove bolt attaching top of front guide bar to inner door panel.
5. Using a Snap-on(R) flare-nut socket (FRXM10) and a hex wrench, remove nut attaching bottom of guide bar to door panel while holding jack
screws.
INSTALLATION
1. Install nut attaching bottom of guide bar to door panel.
2. Install bolt attaching top of front guide bar to inner door panel.
3. Install front lift guide.
4. Install door speaker, if equipped.
5. Verify door glass alignment, adjust if necessary.
6. Install door trim panel and water dam.
B-Pillar Weatherstrip Channel
B-PILLAR WEATHERSTRIP CHANNEL
REMOVAL
1. Remove b-pillar applique.
2. Remove push in fasteners attaching weatherstrip to b-pillar.
3. Pull weatherstrip from b-pillar channels.
4. Remove screws attaching channels to b-pillar.
5. Remove channels from b-pillar.
INSTALLATION
1. Install channels from b-pillar.
2. Install screws attaching channels to b-pillar.
3. Install weatherstrip to b-pillar channels.
4. Install push in fasteners attaching weatherstrip to b-pillar.
5. Install b-pillar applique.
FDR Glass Run Weatherstrip
FDR GLASS RUN WEATHERSTRIP
REMOVAL
1. Remove flag cover, door trim panel, water dam as necessary.
2. Remove door glass.
3. Loosen side view mirror, as necessary.
4. Remove weatherstrip fasteners.
5. Pull weatherstrip from lower front channel above door latch.
