SRT-4 L4-2.4L Turbo VIN S (2004)
Rear Door Panel: Procedures
REMOVAL
1. Release door latch and open door.
2. Lower window glass.
3. Remove window regulator crank.
4. Remove screw from inside arm rest pull cup.
Rear Door Trim
5. Remove screw from behind inside latch release handle .
6. Disengage push in fasteners attaching trim to door panel around perimeter of trim panel.
7. Disengage push-in metal spring clip holding trim in sail flag area.
8. Lift trim panel up off belt weatherstrip.
9. Tilt top of trim panel away from door and disengage clip attaching latch rod to handle.
10. Remove latch rod from handle.
11. Remove trim panel from door.
INSTALLATION
1. Replace any damaged or missing push in fasteners from around perimeter of door trim panel.
2. Place trim panel in position on door.
3. Insert latch rod into handle and engage clip.
4. Engage trim panel into retainer channel at top of door.
5. Locate door trim panel to inner door panel by aligning locating pins on backside of trim panel to mating holes in inner door panel.
6. Engage push in fasteners attaching trim to door panel around perimeter of trim panel.
7. Install screw behind inside latch release handle.
8. Install screw inside arm rest pull cup.
9. Install window regulator crank.
