SRT-4 L4-2.4L Turbo VIN S (2004)
14.
Gently install the pin from the inside of the opening. Push the pin in with punch until the pin is flush with the face of the locker slide side of the
mechanism bracket opening (outboard side). **If the pin or bushing become lost or damaged replacements are available in kit p/n 05174865AA.
15.
Repeat steps 6 - 14 for the other side if necessary.
16.
Make sure the locker slides are engaged and cycle the sunroof to the close position,
17.
Position the glass panel in the roof opening.
18.
Start, but do not tighten, the glass attachment screws. **
19.
Using a business card as a guide, slide the card around the edge of glass panel to ensure panel is centered in the opening.
20.
Position the front of the sunroof glass panel so that the corners are flush to 1.0 mm below the top surface of the roof panel.
21.
Position the rear of the sunroof glass panel so that the corners are flush to 1.0 mm over flush to the top surface of the roof panel.
22.
With the aid of a helper, hold the glass panel in position and tighten glass attaching screws.
23.
Cycle the sunroof and verify proper operation.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
Disclaimer:
This bulletin is supplied as technical information only and is not an authorization for repair.
