SRT-4 L4-2.4L Turbo VIN S (2004)
Power Seat Switch: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
Power Seat Switch
2. Remove the three screws that secure the outboard seat cushion side shield to the seat cushion frame.
3. Pull the outboard seat cushion side shield away from the seat cushion frame far enough to access the power seat switch wire harness connector.
4. Disconnect the power seat wire harness connector from the power seat switch connector receptacle.
5. Remove the two screws that secure the power seat switch to the inside of the outboard seat cushion side shield.
6. Remove the power seat switch from the outboard seat cushion side shield.
INSTALLATION
1. Position the power seat switch onto the outboard seat cushion side shield.
2. Install and tighten the two screws that secure the power seat switch to the inside of the outboard seat cushion side shield. Tighten the screws to 1.5
Nm (14 in. Lbs.).
3. Reconnect the power seat wire harness connector to the power seat switch connector receptacle.
4. Position the outboard seat cushion side shield onto the seat cushion frame
5. Install and tighten the three screws that secure the outboard seat cushion side shield to the seat cushion frame. Tighten the screws to 1.5 Nm (14
in. lbs.).
6. Reconnect the battery negative cable.
