SRT-4 L4-2.4L Turbo VIN S (2004)
19. Road test the vehicle to ensure proper operation of the brakes.
WITH MANUAL TRANSAXLE
1. If the pedal has been removed from its bracket, install the pedal, bushings and bolt-in-shaft on the bracket using the available service parts
package.
2. Install the brake pedal assembly onto the studs extending down from the instrument panel support and power brake booster (Fig. 100).
3. Install the two nuts fastening the brake pedal bracket to the instrument panel support (Fig. 100). Install the nuts all the way, but do not tighten them
at this time.
4. Install the power brake booster mounting nuts. Tighten the four nuts fastening the brake pedal bracket to the power brake booster to a torque of 34
Nm (300 inch lbs.).
5. Tighten the two nuts fastening the brake pedal bracket to the instrument panel support to a torque of 34 Nm (300 inch lbs.).
6. Connect the clutch cable to the clutch pedal spacer on the pedal (Fig. 101).
7. Connect the wiring harness connector going to the clutch pedal switches (Fig. 102).
8. Install the power brake booster input rod on the pin mounted on the side of the brake pedal. Install a new retaining clip on the end of the pin. Do
not reuse the old clip.
9. Mount a new brake lamp switch into the bracket.
10. Install the instrument panel.
11. Check the stop lamps to verify they are operating properly and not staying on when the pedal is in the released position.
12. Road test the vehicle to ensure proper operation of the brakes.
