SRT-4 L4-2.4L Turbo VIN S (2004)
5. Lubricate both adapter caliper slide abutments with a liberal amount of Mopar Multi-purpose Lubricant, or an equivalent.
CAUTION: Use care when installing the caliper assembly onto adapter so the guide pin bushings and sleeves do not get damaged by the
mounting bosses on adapter.
6. Starting with the lower end, carefully lower the caliper and brake shoes over the brake rotor and catch the caliper's bottom edge behind the caliper
slide abutment (Fig. 29). Rotate the top of the caliper into mounting position on the adapter.
CAUTION: Extreme caution should be taken not to cross thread the caliper guide pin bolts when they are installed.
7. Carefully install the caliper guide pin bolts (Fig. 28), then tighten them to a torque of 22 Nm (192 inch lbs.).
8. Install the tire and wheel assembly. Tighten the wheel mounting nuts to a torque of 135 Nm (100 ft. lbs.).
9. Lower the vehicle.
10. Pump the brake pedal to set the brake shoes to the brake rotors, then check brake fluid level in master cylinder reservoir. Adjust brake fluid level
as necessary.
11. Road test the vehicle and make several stops to wear off any foreign material on the brakes and to seat the brake shoes.
