SRT-4 L4-2.4L Turbo VIN S (2004)
Backing Plate: Service and Repair
SUPPORT PLATE - DRUM BRAKE
REMOVAL
NOTE: Before proceeding with this procedure, Refer to WARNING.
1. Using a brake pedal holding tool as shown (Fig. 129), depress the brake pedal past its first one inch of travel and hold it in this position. This will
isolate the master cylinder from the brake hydraulic system and will not allow the brake fluid to drain out of the master cylinder reservoir.
2. Raise the vehicle.
3. Remove the rear tire and wheel assembly from the vehicle.
4. Disconnect the rear brake flex hose from the wheel cylinder (Fig. 130).
5. Remove the rear brake drum.
