SRT-4 L4-2.4L Turbo VIN S (2004)
3. Disconnect the brake fluid level switch wiring connector (Fig. 97).
4. Remove the brake lines from the master cylinder.
5. Remove the (2) master cylinder mounting nuts.
6. Slide the master cylinder assembly straight out of the power brake booster.
Lhd With ABS
INSTALLATION - LHD WITH ABS
NOTE: The master cylinder must be bled before installing it on the vehicle.
1. Bleed the master cylinder before installing it on the vehicle.
2. Inspect and wipe clean the O-ring vacuum seal on the master cylinder rear mounting flange to ensure a good vacuum seal once installation is
complete. Replace as necessary.
3. Wipe the face of the power brake booster clean where the master cylinder seal comes in contact when it's installed. Do not get any cleaner or
debris inside the booster.
4. Position the master cylinder on the studs of power brake vacuum booster aligning the booster push rod with the master cylinder push rod.
Carefully push the master cylinder onto the studs until it contacts the face of the booster.
