SRT-4 L4-2.4L Turbo VIN S (2004)
6. Remove the grommets (0-rings) sealing the reservoir to the master cylinder housing (Fig. 91).
INSTALLATION
1. Install NEW sealing grommets (0-rings) in the master cylinder housing (Fig. 91).
2. Lubricate the sealing grommets with fresh clean DOT 3 brake fluid. Place the reservoir in position over the grommets making sure the filler hole is
towards the front of the vehicle. Seat the reservoir into the grommets. While holding the reservoir firmly against the grommets, install new plastic
pins through their mounting holes until they protrude out the other side of the master cylinder reservoir (Fig. 90).
3. Connect the brake fluid level switch wiring connector (Fig. 95).
4. Fill the reservoir with fresh clean DOT 3 brake fluid.