SRT-4 L4-2.4L Turbo VIN S (2004)
7. Install the 24-way connector into the socket of the CAB as follows:
^
Position the 24-way connector in the socket of the CAB and carefully push it down as far as possible (Fig. 19).
^
When the connector is fully seated into the CAB socket, push the connector lock inward. This pulls the connector into the socket of the CAB
and locks it in the installed position.
8. Position the battery tray back in place. Install the two bolts, then the two nuts mounting the battery tray to its bracket (Fig. 17). Tighten the two
bolts and nuts to a torque of 15 Nm (135 inch lbs.).
9. Reinstall the air cleaner box onto its grommeted alignment post (Fig. 17).
10. Install the one nut and one bolt securing the air cleaner box in place, then connect the wiring harness connector at the air inlet sensor.
11. Install the battery and clamp it in place. Tighten the hold-down clamp bolt to a torque of 12 Nm (105 inch lbs.).
12. Connect the positive, then the negative (ground) cable on the battery.
NOTE: The ICU may need to be initialized using the DRBIII scan tool after ICU installation. Refer to Appropriate Diagnostic Information.
13. Bleed the base brakes and ABS hydraulic systems.
14. Fill the master cylinder to the proper fill level.
15. Road test the vehicle to ensure proper operation of the base and antilock brake systems.
