SRT-4 L4-2.4L Turbo VIN S (2004)
6. Loosen adjustment screw (Fig. 17).
CAUTION: Inspect clutch master cylinder pushrod plastic retainer. If retainer is damaged in any way (broken/cracked) it MUST be replaced.
7. Connect clutch master cylinder pushrod. Gently lift clutch pedal upwards until the clutch pedal fully depresses the the upstop switch. Torque
adjustment screw to 6 Nm (55 inch lbs.).
8. Connect interlock/upstop and stop lamp switch connectors.
9. Install left lower instrument panel bezel (Fig. 12).
10. Connect battery negative cable.
11. Verify proper switch operation.
RHD
NOTE: Proper switch harness routing is critical to switch durability. Note the harness routing and location of fasteners intended to keep wires from
contacting pedals.
1. Install the clutch interlock/upstop switch onto the master cylinder push rod, making sure that the push rod is oriented with the push rod retainer
toward the wiring of the switch. The master cylinder push rod must be snapped into the clutch interlock/ upstop switch along the smaller diameter
of the push rod between the snap ring and the transition to the larger diameter.
CAUTION: Improper assembly of the larger diameter of the push rod into the clutch interlock/upstop switch could cause damage to the switch or
a clutch system failure.
2. Install the switch cover plate.
CAUTION: Inspect the plastic push rod retainer for damage. If it is damaged (broken/cracked), it MUST be replaced.
3. Connect clutch master cylinder pushrod to the clutch pedal pin.
4. Route the wiring harness as it was prior to removal.
5. Secure the switch connector retaining push pin into the appropriate hole in the pedal bracket assembly.
