SRT-4 L4-2.4L Turbo VIN S (2004)
Crankshaft Main Bearing Seal: Service and Repair
CRANKSHAFT OIL SEAL REAR
REMOVAL
1. Remove transaxle.
2. Remove flex plate.
3. Insert a 3/16 flat bladed screwdriver between the dust lip and the metal case of the crankshaft seal. Angle the screwdriver (Fig. 66) through the
dust lip against metal case of the seal. Pry out seal.
CAUTION: Do not permit the screwdriver blade to contact crankshaft seal surface. Contact of the screwdriver blade against crankshaft edge
(chamfer) is permitted.
INSTALLATION
CAUTION: If a burr or scratch is present on the crankshaft edge (chamfer), cleanup with 400 grit sand paper to prevent seal damage during
installation of new seal.
NOTE: When installing seal, no lube on seal is needed.
