SRT-4 L4-2.4L Turbo VIN S (2004)
5. Remove lower bolt attaching timing belt tensioner assembly to engine and remove tensioner as an assembly (Fig. 144).
INSTALLATION
1. Align timing belt tensioner assembly to engine and install lower mounting bolt but do not tighten (Fig. 144). To properly align tensioner assembly
to engine; temporarily install one of the engine bracket mounting bolts (M 10) 5 - 7 turns into the tensioner assembly upper mounting location
(Fig. 144).
2. Torque the tensioner's lower mounting bolt to 61 Nm (45 ft. lbs.). Remove the upper bolt used for tensioner alignment.
3. Install rear timing belt cover and fasteners (Fig. 143).
4. Install timing belt idler pulley and torque mounting bolt to 61 Nm (45 ft. lbs.).
CAUTION: Do not use an impact wrench to tighten camshaft sprocket bolts. Damage to the camshaft to-sprocket locating dowel pin may occur.
5. Install camshaft sprockets. Use Special Tool 6847 to hold sprockets (Fig. 142) and tighten bolts to 115 Nm (85 ft. lbs.).
6. Install timing belt.