SRT-4 L4-2.4L Turbo VIN S (2004)
Control Assembly: Service and Repair
Temperature Control Cable
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove instrument panel center stack bezel.
3. Remove the center air duct from the instrument panel.
4. Remove A/C-heater control.
5. Reach through the instrument panel center air duct opening to access and remove the screw that secures the temperature control cable housing
retainer to the top of the HVAC housing.
6. Disconnect the cable at the A/C-heater control and remove the control from instrument panel.
HVAC Housing Cables - Typical
7. Disconnect the temperature control cable end from the blend door lever.
8. Remove the temperature control cable through the instrument panel A/C-heater control opening.
INSTALLATION
1. Position the temperature control cable through the instrument panel A/C-heater control opening.
2. Reach through the instrument panel center air duct opening to access and reconnect the temperature control cable end to the blend-air door lever.
3. Install and tighten the screw that secures the temperature control cable housing retainer to the top of the HVAC housing. Tighten the screw to 2.3
Nm (20 in. lbs.).
4. Install the A/C-heater control.
5. Install the instrument panel center stack bezel.
6. Reconnect the battery negative cable.
