SRT-4 L4-2.4L Turbo VIN S (2004)
Drive Belt: Service and Repair
Accessory Drive Belt - Installation
GENERATOR BELT
NOTE: When installing drive belt onto pulleys, make sure that belt is properly routed and all V-grooves make proper contact with pulley grooves.
1. Install belt and/or adjust belt tension by tightening adjusting bolt. Adjust belt to specification shown in Belt Tension Chart.
2. Check belt tension using Special Tool 8371 - Belt Tension Gauge Adapter, and the DRBIII using the following procedures:
WARNING: DO NOT CHECK BELT TENSION WITH ENGINE RUNNING.
a. Connect 8371 to the DRBIII following the instructions provided in tool kit.
b. Place end of microphone probe approximately 2.54 cm (1 in.) from belt at one of the belt center span locations shown.
c. Pluck the belt a minimum of 3 times. (Use your finger or other suitable object)
d. The frequency of the belt in hertz (Hz) will display on DRBIII screen.
e. Adjust belt to obtain proper frequency (tension). Refer to the belt tension chart for specifications.
