SRT-4 L4-2.4L Turbo VIN S (2004)
Crankshaft Position Sensor: Service and Repair
REMOVAL
Crankshaft Position Sensor Location
The Crankshaft Position Sensor is in the front of the engine block just under the starter motor.
1. Disconnect the negative battery cable.
2. Raise vehicle and support.
3. On 2.4L SRT-4 remove the lower inner cooler hose from the metal tube.
Structural Collar And Bending Strut - (Automatic Tansaxle Equipped)
4. Remove the Structural Collar, refer to the Engine, Structural Collar Removal and Installation section.
5. Unlock and disconnect the electrical connector to the crankshaft position sensor.
6. Remove the crankshaft position sensor bolt.
