SRT-4 L4-2.4L Turbo VIN S (2004)
Oxygen Sensor: Service and Repair
Removal and Installation
REMOVAL
1. Disconnect the negative battery cable.
1. Unlock and disconnect the electrical connector. It is on the passenger side near the EVAP purge solenoid.
1. Raise vehicle and support.
Upstream O2 Sensor-2.4L Turbo
1. Remove sensor using an oxygen sensor crow foot wrench such as Snap-On tool YA8875 or equivalent
INSTALLATION
1. Install O2 sensor using an oxygen sensor crow foot wrench such as Snap-On tool YA8875 or equivalent and tighten to N.m 28 (20 ft. lbs.).
O2 Wire Routing
2. Route O2 sensor wire above the heat shield for the generator and away from the exhaust manifold.
