SRT-4 L4-2.4L Turbo VIN S (2004)
Wheel Speed Sensor: Testing and Inspection
INSPECTION
Tone wheels can cause erratic wheel speed sensor signals. Inspect tone wheels for the following possible causes:
^
missing, chipped, or broken teeth
^
contact with the wheel speed sensor
^
wheel speed sensor to tone wheel alignment
^
wheel speed sensor to tone wheel clearance
^
excessive tone wheel runout
^
tone wheel loose on its mounting surface
If a front tone wheel is found to need replacement, the drive shaft must be replaced. No attempt should be made to replace just the tone wheel.
If a rear tone wheel is found to need replacement, the rear hub and bearing must be replaced. No attempt should be made to replace just the tone
wheel.
If wheel speed sensor to tone wheel contact is evident, determine the cause and correct it before replacing the wheel speed sensor or tone wheel.
Check the gap between the speed sensor head and the tone wheel to ensure it is within specifications. For wheel speed sensor air gap.
Excessive tone wheel runout can cause erratic wheel speed sensor signals. If tone wheel runout is excessive, determine if it is caused by a defect in the
driveshaft assembly or hub and bearing. Replace as necessary.
Tone wheels are pressed onto their mounting surfaces and should not rotate independently from the mounting surface. Replace the front driveshaft or
rear hub and bearing as necessary.
