SRT-4 L4-2.4L Turbo VIN S (2004)
Wheel Speed Sensor: Service and Repair
Rear
REMOVAL
NOTE: Before proceeding with this procedure, Refer to WARNING.
1. Raise the vehicle.
2. Disconnect the wheel speed sensor cable connector from the vehicle wiring harness (Fig. 10). Remove the clip attaching wheel speed sensor cable
connector to the vehicle's body
3. Remove the wheel speed sensor cable routing bracket from under rear brake flex hose mounting bracket. Then remove the speed sensor cable from
the routing clips on the rear brake flex hose and chassis brake tube.
4. Remove the bolt attaching the wheel speed sensor cable routing bracket to rear strut.
CAUTION: When removing a wheel speed sensor from the rear disc brake adapter, do not use pliers on the sensor head. This may damage the
sensor head. If the sensor has seized, use a hammer and a punch to tap the edge of the sensor head ear, rocking the sensor side-to-side until free.
5. Remove the bolt attaching the wheel speed sensor to the rear disc brake adapter (Fig. 11), then carefully remove the sensor head from the rear disc
brake adapter and vehicle.
