SRT-4 L4-2.4L Turbo VIN S (2004)
1. Disconnect the master cylinder push rod from the pedal pin (Fig. 16). Inspect push rod retainer for damage. If it is damaged (broken/cracked), it
must be replaced.
2. Squeeze together the tangs on the switch cover plate and slide the plate off the switch housing.
3. Disconnect the clutch interlock/upstop switch connector from the instrument panel wiring harness.
4. Remove the switch from the vehicle.
INSTALLATION
LHD
NOTE: Proper switch harness routing is critical to switch durability. Note the harness routing and location of fasteners intended to keep wires from
contacting pedals.
1. Install switches into the pedal bracket assembly as shown in (Fig. 15). Route harness as was prior to removal. Secure switch connector retaining
push pin into the appropriate hole in the pedal bracket assembly
2. Install clutch and brake pedals to pedal bracket, and install pivot shaft and nut. Torque pivot shaft nut to 42 Nm (31 ft. lbs.).
3. Install brake/clutch pedal bracket assembly into position. Install and tighten brake booster mounting nuts to 34 Nm (25 ft. lbs.). Install and tighten
pedal bracket-to-instrument panel nuts to 34 Nm (25 ft. lbs.).
4. Install new stop lamp switch.
5. Connect brake booster rod to brake pedal. Install retainer clip (Fig. 13).
