SRT-4 L4-2.4L Turbo VIN S (2004)
9. Remove the tie rod end from the steering knuckle using Remover, Special Tool MB991113 (Fig. 5).
10. Remove the tie rod heat shield.
11. Remove the nut and pinch bolt clamping the ball joint stud to the steering knuckle (Fig. 6).
CAUTION: The strut assembly-to-steering knuckle attaching bolts are serrated and must not be turned during removal. Hold the bolts stationary
in the steering knuckles while removing the nuts, then tap the bolts out using a pin punch.
12. Remove the two bolts attaching the strut to the steering knuckle.
NOTE: Use caution when separating the ball joint stud from the steering knuckle, so the ball joint seal does not get cut.
