SRT-4 L4-2.4L Turbo VIN S (2004)
Stabilizer Bar: Service and Repair
Front
STABILIZER BAR
REMOVAL
NOTE: Before proceeding with this procedure, Refer to Service Precautions.
1. Raise the vehicle.
2. Remove both stabilizer bar links from the vehicle (Fig. 52). Remove each link by holding the upper retainer/nut with a wrench and turning the link
bolt.
3. Remove the stabilizer bar cushion retainer bolts and retainers (Fig. 52), and remove the stabilizer bar with cushions attached from the vehicle.
4. To remove the cushions from the stabilizer bar, peel back each cushion at the slit and roll it off the bar.
INSTALLATION
NOTE: Before proceeding with this procedure, Refer to Service Precautions. Before stabilizer bar installation, inspect the cushions and links for
excessive wear, cracks, damage and distortion. Replace any pieces failing inspection.
1. If removed, install the stabilizer bar cushions on the stabilizer bar utilizing the slit in each cushion. Position the cushions at each end of the bar's
straight beam, just before it begins to curve.
