SRT-4 L4-2.4L Turbo VIN S (2004)
3. Install both stabilizer bar links back on vehicle (Fig. 52). Start each stabilizer bar link bolt with bushing from the bottom, through the stabilizer bar
, inner link bushings, lower control arm, and into the upper retainer/nut and bushing (Fig. 1). Do not fully tighten the link assemblies at this time.
4. Lower the vehicle.
NOTE: It may be necessary to put the vehicle on a platform hoist or alignment rack to gain access to the stabilizer bar mounting bolts with the
vehicle at curb height.
5. Tighten each stabilizer bar link by holding the upper retainer/nut with a wrench and turning the link bolt. Tighten each link bolt to a torque of 31
Nm (275 inch lbs.).
6. Tighten the stabilizer bar cushion retainer bolts to a torque of 28 Nm (250 inch lbs.).
