SRT-4 L4-2.4L Turbo VIN S (2004)
9. Loosen the push rod adjustment screw (Fig. 38).
10. Install the push rod onto the pedal pin.
11. Gently lift clutch pedal upwards until the clutch pedal fully depresses the upstop switch. Torque adjustment screw to 6 Nm (55 inch lbs.).
12. Install the ABS module/purge solenoid, PDC, and air cleaner.
13. Depress and release the clutch pedal a minimum of ten (10) times to allow any residual air in the system to be vented to the reservoir. If residual
air becomes trapped in the system, bleed the clutch hydraulic system.
14. Connect the negative battery cable.
15. Top off clutch master cylinder reservoir with DOT 3 brake fluid.
16. Verify correct clutch operation.
