SRT-4 L4-2.4L Turbo VIN S (2004)
3. Install outer CN joint assembly onto interconnecting shaft by using a soft-faced hammer and tapping end of stub axle (with hub nut installed) until
outer C/V joint is fully seated on interconnecting shaft (Fig. 50).
4. Outer CN joint assembly must be installed on interconnecting shaft until cross of outer CN joint assembly is seated against circlip on
interconnecting shaft (Fig. 51).
5. Distribute 1/2 the amount of grease provided in seal boot service package (DO NOT USE ANY OTHER TYPE OF GREASE) into outer C/V joint
assembly housing. Put the remaining amount into the sealing boot.
6. Install outer C/V joint sealing boot to interconnecting shaft clamp evenly on sealing boot.
