SRT-4 L4-2.4L Turbo VIN S (2004)
Window Regulator: Service and Repair
REMOVAL
1. Remove door trim panel.
2. Remove door glass from regulator channel.
Tie Strap Door Regulator Cable
3. Cut away the tie strap from the outboard regulator cable.
4. Loosen screws attaching window regulator channel and crank housing to door panel.
5. Disengage screw and bolt heads from keyhole slots in door panel.
6. Loosen bolts attaching window regulator to door panel.
7. Disengage regulator from door panel, and crank housing.
8. Slide regulator rearward and rotate forward end of roller channel through access hole in door panel,
9. Remove window regulator from door through access hole in inner panel.
INSTALLATION
1. Position window regulator and crank housing on door panel through access hole in door panel.
2. Tighten bolts attaching window regulator to door panel.
3. Engage window regulator bolt heads on channel to key hole slots in door panel.
4. Tighten screw attaching window regulator channel and crank housing.
5. Install a new tie strap around the outboard regulator cable and door inner sheet metal.
6. Position glass to regulator roller channel.
7. Tighten fasteners attaching door glass to roller channel.
8. Install door trim panel.
