Stealth V6-2972cc 3.0L SOHC (1995)
Thermostat: Service and Repair
Fig. 70a Thermostat Replacement Procedure
Fig. 71a Thermostat Installation Direction
WARNING: Do not remove pressure cap while engine is hot or under pressure.
1.
Drain coolant to level below thermostat housing.
2.
Remove upper radiator hose (6), two housing retaining bolts, housing (7), gasket (8) and thermostat (9).
3.
Clean mating surfaces and close drain.
4.
Reverse removal procedures to install.
5.
Refer to the picture above before installing thermostat.
6.
Ensure that drain is closed, then refill coolant. Replace cap, start engine until warm. Check of leaks, then recheck coolant and fill if necessary.
