Stealth V6-2972cc 3.0L SOHC (1995)
Turn Signal Lamp: Description and Operation
Turn Signal and Hazard Light
1. When operation is normal
-.
When the ignition switch is switched to the ON position, battery voltage is applied (via the multi-purpose fuse (11) and hazard switch) to the
turn-signal and hazard flasher unit.
-
When the turn-signal switch is switched to the LH (or RH) position, Tr (within the flasher unit) is switched ON and OFF repeatedly. Then the
contacts of the relay (also within the flasher unit) repeatedly switch from ON to OFF, causing the turn-signal lights and turn-signal indicator
light LH (or RH) to flash.
2. If one of the bulbs is burned out
-
If either of the turn-signal light bulbs is burned-out, the resistance of the turn-signal circuit as a whole increases, resulting in shorter ON and
OFF intervals of the Tr and a higher flashing rate of the lights.
Hazard-Warning Lights
-
When the hazard-warning switch is switched to the "ON" position, the relay contact of the turn signal and hazard flasher unit is switched ON and
OFF repeatedly, in the same manner as for the operation of the turn-signal lights, and the left and right turn-signal lights and turn-signal indicator
lights simultaneously flash repeatedly.
NOTE:
1. The number of flashes of the hazard-warning lights does not change if there is damaged or disconnected wiring of one light.
2. The light automatic shut-OFF system is valid for the illumination light of the hazard switch. See: Tail Lamp/Description and Operation
