Stealth ES V6-2972cc 3.0L DOHC (1991)
reference as needed.
Completion Reporting and Reimbursement
Claims for vehicles which have been serviced must be submitted on the DIAL System.
Claims submitted will be used by Chrysler to record recall service completions and provide dealer payments.
Use the following labor operation number and time allowance:
Labor Operation
Time
Number
Allowance
Replace both front brake hoses
05699182
0.8 hours
Add the cost of the recall parts package plus applicable dealer allowance to your claim.
Note:
See the Warranty Administration Manual, Recall Claim Processing Section for complete recall claim processing instructions.
Parts Return
Not required.
Vehicle Not Available
If a vehicle is not available for service for a known reason, let us know by filling out the pre-addressed Vehicle Disposition Form portion of the Owner
Notification Form or describe the reason on a postcard and mail to:
Chrysler Corporation
CIMS 482-00-85
800 Chrysler Drive East
Auburn Hills, Michigan 48326-2757
Following the above procedures will expedite the processing of your claim.
If you have any questions or need assistance in completing this action, please contact your Zone Service Office.
Service Procedure
1.
Inspect the master cylinder brake fluid reservoir to insure that the fluid level is correct and the cap is securely installed.
2.
Remove the brake lamp fuse from the fuse block below the instrument panel (Fuse # 17) to prevent discharging the battery.
3.
Install a brake pedal fixture to keep the master cylinder in the applied position, such as a prop rod from the brake pedal to the driver seat. Apply
minimal pedal effort to avoid high pressure.
NOTE:
Only the front brakes will require bleeding if the master cylinder remains applied.
4.
Raise the vehicle to a working level on an appropriate hoist.
5.
Remove both front wheel and tire assemblies.
6.
Clean any loose debris from the area around both left front brake hose connections using shop air.
CAUTION:
Wear safety goggles.
