Stealth R/T V6-2972cc 3.0L DOHC (1991)
7.
Tighten the installation screws.
8.
Reconnect the the TPS electrical connector.
DOHC Throttle Position Sensor Connector
9.
Without disconnecting the Control Unit connectors, connect a voltmeter to the Control Unit.
10.
Without starting the engine turn the ignition switch to the ON position, and check the TPS output voltage. 0.4-1.0 volts
If the voltage is out of specification, test the Throttle Position Sensor, its electrical connections and wiring harness.
11.
Turn OFF the ignition switch.
12.
Remove the feeler gauge.
13.
Adjust the tension of the accelerator cable.
