Stealth R/T V6 Power Steering Pump Overhaul - Service and Repair
NOTE: Assemble pump in reverse order of numbered sequence shown, noting the following:
1. Apply power steering fluid to all O-rings prior to installation.
2. Fit spring to pump body with large diameter end facing terminal assembly side.
3. Align dowel pin hole of side plate with dowel pin of pump body when installing side plate.
4. Install cam ring with punched mark facing side plate.
Rear Power Steering Pump
Fig.7 Rear Power Steering Pump Replacement
The rear system power steering pump is not serviceable. If a malfunction or leak should occur, the pump assembly should be replaced.
1. Drain rear power steering fluid.
2. Remove exhaust system to gain access and clearance.
3. Remove rear shock absorber lower mounting bolt.
4. Remove crossmember bracket and crossmember mounting nut on differential side.
5. Remove pressure hose and suction hoses.
6. Remove rear power steering pump.
7. Reverse procedure to install, noting the following:
a. Refill fluid to specified level, then bleed system of air.
